Select the movie for transfer as described below.
Select a movie in full-frame or thumbnail playback.D4S, D4, D800, D800E, and D7000: Transfer mode and PC modeīut note that the Auto send and Send folder options are not supported in Transfer mode.įollow the steps below to transfer movies in Transfer mode.Movie transfer is supported in the following modes: Transferring Movies Recorded with a D4S, D4, D3S, D800, D800E, D300S, or D7000 (WT-4)
Users of the D800 and D800E should upgrade to firmware versions A 1.10 and B 1.10. UT-1 firmware: Be sure the firmware has been upgraded to the latest version.
Windows 8.1 and Windows 10: Ad-hoc mode wireless connections are not supported.WT-5 wireless transmitters (compatible with D5, D4S and D4 cameras).WT-6 wireless transmitters (compatible with D6 and D5 cameras).D5, D4S and D4 cameras (compatible with built-in camera Ethernet).D6 cameras (compatible with built-in camera Wi-Fi and Ethernet).Z 9, Z 7, Z 7II, Z 6, Z 6II, Z 5, Z 50, Z fc, and D780 cameras (compatible with built-in camera Wi-Fi).Colors: 24-bit color (True Color) or more.Resolution: 1024 × 768 pixels (XGA) or more (1280 × 1024/SXGA or more recommended).Intel Celeron, Pentium 4, or Core series, 1.6 GHz or betterĪ minimum of 500 MB available on the start-up disk (1 GB or more recommended) Note: Pre-installed 64-bit editions only. Wireless Transmitter Utility Version 1.9.6 Read the information below before proceeding.This can be resolved by disconnecting the computer from the LAN. Computers may be unable to pair with the camera while connected to a LAN.- Profiles for the WT-4 ( Transfer mode and ftp upload profiles excepted).- Image transfer or Camera control mode profiles for D4 cameras connected via Ethernet or WT-5 wireless transmitters.Users will need to redo the following network profiles (camera network settings) after upgrading from the WT-4 Setup Utility or Wireless Transmitter Utility version 1.3.0:.Installing the Wireless Transmitter Utility uninstalls the WT-4 Setup Utility.Windows security prompts will be displayed two or three times during installation.The software does not support the following WT-4 modes: Thumbnail select mode and Print mode.When performing the update, log in to an account with administrator privileges.Before beginning installation, exit the Wireless Transmitter Utility and all other applications, including any anti-virus software.This software is for users of WT-7, WT-6, WT-5, and WT-4 wireless transmitters, UT-1 wireless communications units, and cameras with built-in Wi-Fi and/or Ethernet.